To calculate the overall star rating and percentage breakdown by star, we do not use a simple average. Instead, our system considers things like how recent a review is and if the reviewer bought the item on Amazon. It also analyses reviews to verify trustworthiness.
El producto funciona bien, solo que en las instrucciones menciona que hay que dejar reposar una hora después de amazar y así no funciona. Volví a amazar otro pedazo y lo apliqué de inmediato, lo dejé secar todo un día y funcionó bien, ahora hay que ver si realmente resiste altas temperaturas.
como lo dice el titulo solo he tenido la ocasión de usarlo una vez al reparar una pequeña fuga en el escape de mi motoneta y quedo perfecto. La uso casi a diario y la reparación ya tiene varias semanas y sin problemas y solo use un poco. Recomiendo este producto definitivamente.
I actually really like this stuff. I fixed my BMW 740IL Transmission Cooler Regulator Valve that I broke a female fitting off of. It takes a lot to knead this stuff thoroughly to a nice goldish brown color and it’s almost like a dense playdoe when applying it. And yes you can smooth it out with a little water on your fingers before the epoxy is cured. I let it sit over night and today the stuff is hard as a rock. If your using it on plastics like I did, be sure to take 90 grit sand paper and scratch up the surface your applying it to. I noticed it didn’t stick when I got some on the smooth surface of the valve. We’ll see if it leaks under operating pressures and engine antifreeze temps. I’ll update the review once I get the car all back together and perform a leak check.
I have/had a leaking and cracked EGR tube at a cast iron manifold. Used this epoxy around the tube at the crack. Using a remote temp sensor (250F limit?) I think the temp only got to around 250F right next to the manifold...so it should work on most parts of an exhaust except a cast iron manifold and maybe near a cat converter. Also used it to seal around a muffler connx. Time has not passed yet though...durability?
Tried using furnace cement with fiberglass added and covered with alum sheet and clamp...did not last.
I've used putty epoxy (different brands) to seal a rusted galvanized water pipe and it has lasted for maybe 5 yrs....also used it with concrete outdoors and it has lasted at least 10 yrs. Wonderful stuff if used correctly...clean surfaces well using sandpaper...knead well and into surfaces.
A reviewer above said it worked great for their chimenia, and I'm sure it did. But for my chimenia it wasn't what I was looking for. My chimenia broke off cleanly in a few large chunks when I put the pieces back on you could only barely see the cracks as hairlines. This epoxy may work fine but it's a putty and it takes up too much space in the crack, so it didn't allow the pieces to be put exactly back in place. What I need is some kind of liguid or gel that doesn't take up space.
I had a small exhaust leak I sealed with this at the manifold in my truck, still not sure if this will hold up, but so far a few days has passed and I haven't had a problem......so Time will tell I guess!! Other than that good product as far as "ease of use" and got into the tight spot I needed to seal the leak at!!